Principle introduction: [[[DTI 18N_TAG_3]]]
The welding smoke absorbed by the suction hood enters the interior of the filter unit through the suction arm. It first hits the splitter plate, changes the direction of the airflow, and makes the airflow flow upward. This avoids direct impact on the filter element and is also circulated. Large particles of dust are separated before being collected by the filter cartridge. Small particles are filtered and separated by the filter cartridge of the filter membrane. The filtered clean air is discharged to the outside through silencer, completing the entire filtration process. The smoke particles separated by the filter cylinder with a filter membrane fall into the dust container under the action of pulse backflush and are collected.
Rh type welding smoke trap, the filter cartridge is installed horizontally. The filter material used in the filter cartridge can ensure the dust cleaning effect and long service life of the filter cartridge. It adopts the cartridge filtration method to meet the indoor emission standards stipulated by the country. It is a brand-new purification equipment. [[[DTI18N_TAG _13]]]
Performance features: [[[D TI18N_TAG_18]]]
- Suitable for a variety of welding stations
- Assembled with imported components
- Large air volume, low noise, good smoking effect[[[DTI18N_TAG _36]]]
- - PLC microcomputer automatically controls dust cleaning[[[DTI18N_TAG _52]]]
- Easy to use and can be moved anywhere[[[DTI18N_TAG_ 60]]]
- Can be equipped with hose or hard tube
[[[DTI18N_TAG_7 0]]]Technical performance:[[[DTI18N_TAG _76]]]
Application scope:
Welding fume, cutting fume, grinding dust.
